Product Description

The loading zone of a conveyor is a critical area from maintenance and spillage point of view.

 The type and size of material as well as height of drop are the main factors causing damage 

not only to belt but also the rubber rings and bearings of the conventional impact idler rolls.

 All of these lead to seizure and breakdown of impact rolls, meaning severe downtime problems

The impact bar is a combination of three different layers. The top layer is made of UHMWPE for 

smooth movement of belt, thanks to its low dynamic co-efficient of friction. The middle layer is

of rubber to cushion the impact load while the lower layer is made of aluminum, which acts as a

 fastening device with the main support frame or cradle. The cradlers are custom built to suit 

specific applications. The installation of impact bar is made is such a way that the belt is not

 in touch with the bar when running empty. The belt comes in contact with the bar only when it is

 running under loaded condition.

Feasures:

•UHMWPE surface with extremely low coefficient of friction on the top of impact bars will reduce 

  effectively the wear on the      conveyor belt.

•Shock absorbing rubber can absorb maximal impact of materials.

•“T-slot” extruded metal construction allows fixing of our impact bars along the entire length 

  of the impact bar which allows for  easier installation and disassembly.

•Manufactured by hot vulcanization which leads in an efficient and reliable joining between the parts.

Note: Flame Retardant Impact Bar–With quality approval on the “Flame Resistant and Anti-static”abi

lity for Underground Coal Mine Industry, and got “Certificate of Qualified Products” issued by “China

 National Inspection & Supervision Center of Coal Mine Equipment”

Advantages:

1. Avoids the dage to the belt through the contact between the bar and surface of belt. 

2. The conveyor belt is stressed evenly in the loading area, which will reduce the daily maintenance cost.

 It effectively eliminates     the spillage or scattering of the material causedby inequality of the stress

 on the belt.

3. The UHMW polyethylene surface has outstanding sliding properties, to reduce the frictional resistance to

 the minimum. 

4. Ultra elastic rubber absorbs the impact in the maximum. 

5. Each part of the impact bar is closely jointed by hot vulcanization.

6.“T-track” fastening device has different tightening points along the bar and make the joining strong and

 reliable, easy to install      and remove.The impact bar is a combination of three different layers. The top

 layer is made of UHMWPE for smooth movement of belt, thanks to its low dynamic co-efficient of friction.

The middle layer is of rubber to cushion the impact load while the lower layer is made of aluminum, which actsas

 a fastening device with the main support frame or cradle. The cradlers are custom built to suit specific applications.

 The installation of impact bar is made is such a way that the belt is not in touch with the bar when running empty.

The belt comes in contact with the bar only when it is running under loaded condition.